Most Recent Dell EMC DES-5121 Exam Dumps

Prepare for the Dell EMC Specialist – Implementation Engineer, Campus Networking Version 1.0 exam with our extensive collection of questions and answers. These practice Q&A are updated according to the latest syllabus, providing you with the tools needed to review and test your knowledge.

QA4Exam focus on the latest syllabus and exam objectives, our practice Q&A are designed to help you identify key topics and solidify your understanding. By focusing on the core curriculum, These Questions & Answers helps you cover all the essential topics, ensuring you're well-prepared for every section of the exam. Each question comes with a detailed explanation, offering valuable insights and helping you to learn from your mistakes. Whether you're looking to assess your progress or dive deeper into complex topics, our updated Q&A will provide the support you need to confidently approach the Dell EMC DES-5121 exam and achieve success.

The questions for DES-5121 were last updated on Jun 5, 2026.

Viewing page 1 out of 13 pages.
Viewing questions 1-5 out of 65 questions

Get All 65 Questions & Answers

Question No. 1

You are tasked with deploying a single Dell EMC N-Series switch with a 2-port port-channel to uplink to an existing upstream switch. The following reflects the upstream switch configuration:

N4032F#show running-config interface tengigabitethernet 1/0/5

channel-group 1 mode on

N4032F#show running-config interface tengigabitethernet 1/0/6

channel-group 1 mode on

Which type of port-channel should be configured to successfully uplink?

AActive

BMLAG

CStatic

DPassive

Show Answer

Correct Answer: C

Question No. 2

N4032F#show interfaces status

N4032F#show interfaces port-channel 1

Hash Algorithm Type

1 - Source MAC, VLAN, EtherType, source module and port Id

2 - Destination MAC, VLAN, EtherType, source module and port Id

3 - Source IP and source TCP/UDP port

4 - Destination IP and destination TCP/UDP port

5 - Source/Destination MAC, VLAN, EtherType, source MODID/port

6 - Source/Destination IP and source/destination TCP/UDP port

7 - Enhanced hashing mode

N4032F#

A Dell EMC N-Series switch has been configured with a 2-member port-channel; however, only one link is currently active.

Based on the exhibit, why is only one link active?

AMinimum links value for Po1 is set to '1'

BHash algorithm is configured for active-passive

CTe1/0/6 interface is administratively disabled

DSpeed setting is different between ports

Show Answer

Correct Answer: D

Question No. 3

Which type of an attack is considered MAC poisoning?

ADuplicating the MAC address of a legitimate device so frames are forwarded to the incorrect port

BHost imitating a trunk port by using tagging and trunking protocols

CFlooding MAC addresses to the switch to fill its CAM table, causing the switch to act as a hub

DHost on a VLAN gaining unauthorized access to other VLANs on the network

Show Answer

Correct Answer: A

Question No. 4

An administrator just finished configuring a Dell EMC N-Series switch. After rebooting the switch, the administrator notices that all the configuration settings just entered are gone.

Which command did the administrator fail to enter?

ACopy running-config startup-config

BCopy running-config backup-config

CCopy startup-config backup-config

DCopy startup-config running-config

Show Answer

Correct Answer: A

Question No. 5

Which function does a VRRP backup router perform?

ASends keepalive advertisements to the other backup routers

BProcesses and responds to ARP requests

CForwards packets to the Master with a destination IP of the virtual IP address

DReceives packets with the virtual MAC address as the destination for other backup routers

Show Answer

Correct Answer: D

Unlock All Questions for Dell EMC DES-5121 Exam

Full Exam Access, Actual Exam Questions, Validated Answers, Anytime Anywhere, No Download Limits, No Practice Limits

Get All 65 Questions & Answers