Questions 1 to 5 of the 60-question H35-480_V3.0 bank, each with its correct answer and an explanation. 1 of 5 ask for more than one answer. This is page 1 of 12.
The RSRP value of the test terminal can be viewed on the GENEX Probe. Which of the following test results indicate good signal quality?
'The RSRP value of the test terminal can be viewed on the GENEX Probe. A RSRP value of between -60dBm and -90dBm indicates good signal quality. Lower values indicate weaker signals, while higher values indicate stronger signals.'
Which of the following 5G massive MIMO scenarios is more suitable for high rise office building coverage?
H110V6 refers to a scenario where there are 110 horizontal and 6 vertical antenna elements installed on the gNodeB, which is ideal for providing coverage in high-rise office buildings. The high number of horizontal antenna elements allows for high-density deployment, which can improve the coverage and capacity of the network in these types of environments.
'H110V6 can be used to cover high-rise buildings, such as office buildings and hotels, which have complex indoor environments. The high number of horizontal antenna elements can provide strong coverage and capacity.' in Huawei official website.
In NSA networking, which of the following modes is used to anchor 5G NR?
The non-standalone (NSA) mode of 5G NR refers to an option of 5G NR deployment that depends on the control plane of an existing 4G LTE network for control functions, while 5G NR is exclusively focused on the user plane.[7][8]This is reported to speed up 5G adoption, however some operators and vendors have criticized prioritizing the introduction of 5G NR NSA on the grounds that it could hinder the implementation of the standalone mode of the network
Which of the following NR channels or signals supports static and dynamic power control?
Static power control is used to adjust the transmission power of UEs to meet the requirements of cell-edge UEs, while dynamic power control is used to adjust the transmission power of UEs to meet the requirements of the uplink channel quality. PUSCH is the channel used by the UE to transmit data to the gNodeB and supports both static and dynamic power control.
'The PUSCH (Physical Uplink Shared Channel) supports both static and dynamic power control. Static power control is used to adjust the transmission power of UEs to meet the requirements of cell-edge UEs, while dynamic power control is used to adjust the transmission power of UEs to meet the requirements of the uplink channel quality.' in Huawei official website.
Which of the following methods can be used to obtain VLAN IDs after a base station is powered on? (Choose All that Apply)
According to the Huawei SA Networking Product Design Guide (https://www.huawei.com/en/doc/e_huaweidoc/pdf/HW_051525), VLAN scanning is used to detect VLANs in a network. The VLAN scanning process is initiated on the base station and requires the base station to send a query to the Layer 2 switch. The query contains the VLAN ID, and the Layer 2 switch then responds with the list of interfaces that are associated with that VLAN ID. Configuration on the LMT is used to configure the VLAN and assign it to the base station. Finally, remote DHCP assignment is used to assign IP addresses to the base station from the DHCP server.
Full exam access, validated answers, and unlimited practice with no download limits.
