H35-481_V2.0 Exam Dumps and Practice Questions

The UE inactivity timer on the NR side expiring and the air interface link on the NR side being abnormal, and a UE reporting SCG Failure Info to the eNodeB, can both trigger the MeNB to release the SgNB. Other actions, such as an inter-SgNB cell change or the MeNB detecting an abnormal X2 link, may also lead to SgNB release, but are not the trigger for it.

Extended Cyclic Prefix - an overview | ScienceDirect Topics

https://www.sciencedirect.com/topics/engineering/extended-cyclic-prefix

5G NR Numerology - Subcarrier Spcaing (SCS) - Techplayon

http://www.techplayon.com/5g-nr-numerology-subcarrier-spcaing-scs/

Interconnection through RF modules (A) is also a supported solution for X2 interconnection between LTE and NR base stations. In this solution, the LTE and NR base stations are connected through RF modules, allowing them to share the same frequency band and resources. This solution is particularly useful for scenarios where there is a need for seamless interworking between LTE and NR networks, such as in the early stages of 5G deployment.

The GUI configuration mode in MAE-Deployment can be used to configure parameters in an MO and reconfigure a single NE. It cannot be used to configure parameters in multiple MOs or to batch reconfigure multiple NEs. According to the Huawei official documentation, 'The GUI configuration mode can be used to configure parameters in an MO and reconfigure a single NE. However, it cannot be used to configure parameters in multiple MOs or to batch reconfigure multiple NEs.'

According to Huawei official documentation, B. Batch reconfiguration of NEs is a scenario that can be performed using the radio data planning file in the MAE-Deployment. The radio data planning file can be used to perform batch reconfiguration of NEs, such as the configuration of multiple NEs in a batch. The radio data planning file can be used to import data, perform parameter configuration, and export the configuration results. The other options are not performed using the radio data planning file in the MAE-Deployment.

The destination address route configuration is not applicable when multiple IP addresses with different next hop addresses are planned for the gNodeB. Destination address route configuration is used when a single IP address is used by the gNodeB and the next hop address and outgoing interface do not need to be configured. In the case of multiple IP addresses with different next hop addresses, direct route configuration should be used. Direct route configuration requires that the IP address, next hop address, and outgoing interface all be specified for each IP address.